Blog

To replace an oil pump, follow these steps: drain the oil, remove the engine cover, disconnect the old pump, install ...

Replacing a torque converter typically takes around 5 to 8 hours. The torque converter is a vital component in an ...

To test a torque converter, follow these steps: 1) disconnect the torque converter from the engine; 2) use a torque ...

To test a starter relay, you can use a multimeter to check for continuity between the terminals. A starter relay ...

To bypass a starter relay, locate the relay, remove it, and connect the two terminals directly. Starters in vehicles rely ...

To determine if your car has a kill switch, check for a hidden button or switch near the driver’s seat ...

To flush a power steering system, start by raising the front of the vehicle and removing the return line from ...

No, you cannot jumpstart a car with a bad alternator. The alternator is responsible for recharging the battery, so if ...

Starter on cars usually last around 100,000 to 150,000 miles before needing replacement. As a vital component in the vehicle’s ...

To clean a mass air flow sensor with alcohol, follow these steps: disconnect the sensor, remove it from the housing, ...

To reset a mass air flow sensor, disconnect the negative battery cable for 10 minutes and then reconnect it. The ...